\n\n
Four systems cover almost every part: the pan assembly (drum, perforations, baffles, motor and gear box), the spray system (guns, peristaltic pump, tubing, spray arm), the air handling system (AHU with filters and heating, inlet and exhaust ductwork, blowers), and the controls (PLC, HMI, sensors). Loading, discharge and CIP parts sit alongside them.<\/p>\n\n<\/div>\n<\/div>\n
\n
<\/span>Delikli kaplama tavas\u0131 ile standart kaplama tavas\u0131 aras\u0131ndaki fark nedir?<\/span><\/h3>\n\n\n
A standard pan is a tilted, solid drum where heated air passes over the exposed bed surface, so drying is slower and it suits sugar coating and small batches. A perforated pan has thousands of small holes in the shell, so process air passes straight through the tumbling bed. That through-drying is why the perforated pan became the default for aqueous film coating.<\/p>\n\n<\/div>\n<\/div>\n
\n
<\/span>Hangi tablet kaplama makinesi par\u00e7alar\u0131 en \u00e7abuk a\u015f\u0131n\u0131r?<\/span><\/h3>\n\n\n
The spray gun parts – fluid nozzle, air cap and needle – wear first, because they sit in an abrasive coating stream. Peristaltic pump tubing is next: it thins from constant pinching and quietly drops the flow rate, so coat weight comes in low with no alarm. Door seals and plenum gaskets fail quietly too, and show up as longer drying rather than as a fault code.<\/p>\n\n<\/div>\n<\/div>\n
\n
<\/span>Benim parti b\u00fcy\u00fckl\u00fc\u011f\u00fcm i\u00e7in bir kaplama tavas\u0131na ka\u00e7 adet p\u00fcsk\u00fcrtme tabancas\u0131 gerekir?<\/span><\/h3>\n\n\n
Work from bed width, not from batch weight. The guns sit at equal spacing across the bed, and their spray fans must overlap slightly without doubling up. A wider drum needs more guns to hold that coverage, and the pump has to deliver the combined flow. Undersize either one and the batch runs long.<\/p>\n\n<\/div>\n<\/div>\n
\n
<\/span>Tek bir kaplama makinesi hem sulu hem de solvent bazl\u0131 kaplamay\u0131 ger\u00e7ekle\u015ftirebilir mi?<\/span><\/h3>\n\n\n
Sometimes, but only if it was specified for both from the start. Solvent coating needs explosion-proof motors, sensors and control panels, plus solvent recovery on the exhaust. An aqueous-only machine cannot be upgraded to that safely later, so decide the solvent before you order.<\/p>\n\n<\/div>\n<\/div>\n
\n